Recent content by kenogren

Thanks again for the information. I didn't think to disconnect the 12 volt. I haven't seen corrosion. I did look at the lower disconnect and the connections on the drivers rear of the lower battery. I only separated the larger connector, as I mentioned the plastic seems to be brittle and I...

Thank you for the insight. are the connectors in question primarily the one to each battery? The Tyco Electronics C1822B connector that you reference appears to be the one at the driver's rear wheel well. This connector seems to be old and brittle and covered in road grit. Are these...

Thank you for getting back. Yes I have downloaded the manual, although I am not having any luck locating an image of where the drain plugs may be. I was able to get the push pins free without breaking anything :) , but was unable to see anything I identified as a drain plug :( I hooked up the...

I have the car up on jack stands and have disconnected the HV disconnects. I am looking for the drain that would tell me if I have a leak into one of the batteries. No luck so far. I have removed the cover from the upper battery. Not having much luck getting the push pins to free up on the...

I finally found time to check into this. I drove the car for about a two mile round trip today for the first time since I got this error on June 9th. No issues on the drive. I'm not that familiar with checking this stuff, but this is what I see that seems to be relevant. I got Successful...

I received the SSN message on my way home from work. Waited a minute or two and restarted the car and drove home with no problem. I checked under the hood and found that the 12v battery showed about 12.8 volts. Coolant was at or slightly below minimum. I looked around to see if I could...

I am not aware of a way to change go times in the Ford focus Electric's User interface.

I think it is interesting that my car is still preheating itself in the mornings, even though the app and website are not functioning. I also wonder how I would make it stop, if I wanted to?

I was thinking that I don't have a cell signal at my house, but in review I realized that AT&T makes it here a bit.

I am curious, will the application be sunset, or is it just not being able to get a 3g signal? One of the reasons I ask is that I am in an area where there is no signal right now, and the system works fine. Is buying the modem and installing it something the end user can do? Do you need to...

Thanks for the help. The heat is working well.

I ran them all at first about a 1/3 of the way open and about 1/3 speed. Maybe for 5 minutes or so. That is when the tank went down most significantly. I didn't see a degas mode. I just manually ran it. i tested the heat after that, but had none still. I ran it starting at 1/2, then opened...

I figured out how to command the valves open, and the pumps to run. I got the degas tank to drop about 10oz or so. I ran the cabin pump with the heater on and got heat in the car. Now to test it on the road. Wish me luck.

I got my obd scanner, and borrowed a laptop. i have the FORscan installed, had to install the drivers for the scanner. got it up and running and it is connected. i see there are some error codes, the coolant pump A being one. I see where and how to get the controls into the dashboard and...

I have a vacuum pump. What is the concept being implemented to remove the trapped air. Perhaps I can hook up my vacuum pump to remove it?