Below are two DTCs pulled from FORscan.
This one pops up when attempting remote start:
===BdyCM DTC P1594:04-28===
Code: P1594 - Forced Engine Shutdown - Remote Start System Fault, No Unattended Vehicle Timeout
Additional Fault Symptom:
- System Internal Failures
Status:
- Previously Set...
Thanks.
The non-OBD2 methods didn't work so I reset it using FORscan. Got success message but unfortunately the remote start still fails after few seconds.
Looks like it'll be a trip to the dealer.
Appreciate everyone's help on this!
With a battery tender attached, the battery voltage when off was 13.1. Dropped to 12.8 when I attempted remote start; this time the remote start failed immediately and didn't start at all. The battery tender is charging the battery right now. Will see how that goes.
Battery tender shows FULL...
Yes I agree with everything you're written above... will check the battery voltage in a day or two and report back. What should it read on a healthy battery?
I checked with local Ford dealer, they say its not an AGM battery. The stock 67R is a regular flooded cell battery.
The 26R is slightly smaller than the 67R so possible that it may not be providing enough power for remote start.
New problem now since the 12v battery change: remote start not working properly.
Car starts remotely and shuts down after few seconds. Tried with key fob and FordPass app - same result with both.
I've tried setting Climate Control option to Auto and Restore Last Setting.
Tried remote start with...
Thanks for that. I've looked at ICE Focus videos as well and for the most part its the same procedure. But the EV doesn't have as much space to move and lift that front piece out of the way. The wiring loom is jammed against an electrical box.
I ended up calling a mobile battery service to get...
Hi all, need some help here.
Have a 2017 FFE. Trying to remove the 12v battery but can't seem to get that front tray to lift up in order to slide the battery out.
Can anyone help with step by step instructions please? I'm hoping there aren't too many parts to remove to get the battery out.
Thanks